MCQ Bhakti & Sufi Movements SET 14

1. An Indian rubber cube of side 10 cm has one side fixed while a tangential force of 1800 N is applied to the opposite side. Find the shear strain produced. Take η = 2 x 10⁶ N/ m².

0.09

0.009

0.9

Your comments:

Question 1 of 10

2. The length of the wire is increased by 1 mm on the application of a given load. In a wire of the same material but of length and radius twice that of the first, on application of the same force, extension produced is

0.25 mm

2 mm

4 mm

0.5 mm

Your comments:

Question 2 of 10

3. Young's modulus is defined as the ratio of longitudinal stress to longitudinal strain. Which of the following is the unit of Young's modulus?

dyne per square cm.

dyne cm²

dyne/cm

dyne cm

Your comments:

Question 3 of 10

4. The volume of a spherical body is decreased by 10^-3% when it is subjected to pressure of 40 atmospheres. Find the bulk modulus of body.
(1 atm = 1.01 x 10³ N/m²).

4.04 x 10¹¹ N/m²

4.04 x 10⁶N/m²

4.04 x 10³ N/m²

4.04 x 10² N/m²

Your comments:

Question 4 of 10

5. A wire of length L and cross section area A is made of a material of Young's modulus Y. If the wire is stretched by an amount x, the work done is

Your comments:

Question 5 of 10

6. How does the modulus of elasticity change with temperature?

It does not depend on temperature

It decreases with increase in temperature

It increases with increase in temperature

It sometimes increases, sometimes decreases with increase in temperature

Your comments:

Question 6 of 10

7. What type of stress is produced in a body when the deforming force produces sheer strain?

Tangential stress

Longitudinal stress

Normal stress

shear stress

Your comments:

Question 7 of 10

8. Modulus of rigidity is defined as the

ratio of tangential stress to tangential strain

ratio of normal stress to sheer strain

ratio of normal stress to tangential strain

ratio of tangential stress to sheer strain

Your comments:

Question 8 of 10

9. Which of the following represents Hooke's Law?

Your comments:

Question 9 of 10

10. An iron bar of length l cm and cross section A cm2 is pulled by a force F dynes from the ends so as to produce an elongation l cm. Which of the following statements is correct?

Elongation is directly proportional to area of cross-section A.

Elongation is inversely proportional to length.

Elongation is inversely proportional to area of cross-section A.

Elongation is directly proportional to Young's modulus.

Your comments:

Question 10 of 10

Leave a Reply Cancel reply